Shape and volume optimization of industrial parts
Slovak University of Technology in Bratislava, Faculty of Mechanical Engineering, Nam. Slobody 17, 812 31 Bratislava, Slovak Republic.
Research Article
Global Journal of Engineering and Technology Advances, 2022, 10(01), 058–064.
Article DOI: 10.30574/gjeta.2022.10.1.0165
Publication history:
Received on 13 November 2021; revised on 20 December 2021; accepted on 22 December 2021
Abstract:
In the present time, there are many challenges in the production of industrial parts. Due to the constantly rising prices of materials and energy, it is necessary to constantly look for ways to optimize production costs and optimize material consumption. There is great pressure on economical production, i. to produce products with the lowest costs given the expected and necessary properties. With the introduction of additive manufacturing technologies into practice and the production of parts for end use comes the introduction of methods for optimizing the shape of the part and the required amount of material for its production. We call this method Topological Optimization. The presented article describes the preparation of topologically optimized parts and a comparison of their strength properties with respect to the original and the original part.
Keywords:
Topology optimization; Computer simulation; Component Strength; Shape optimization; Volume optimization
Full text article in PDF:
Copyright information:
Copyright © 2022 Author(s) retain the copyright of this article. This article is published under the terms of the Creative Commons Attribution Liscense 4.0